100 Series 
FABRICATED DOORS 

FREEMAN MARINE'S full selection of fabricated doors assures the right door for the right location. These heavy-duty, watertight and weathertight doors are designed for continuous, trouble-free service and oceangoing duty. All doors are made to order, to assure the customer of the correct size door, whether for new construction or refit. 

Fabricated doors are normally sold by the clear-opening sizes. However, they can also be ordered by the overall flange-to-flange sizes, or to fill an existing opening. If an old door is being replaced, advise us of the bulkhead opening, measured after the old door AND frame are removed, and we will provide a door to fill that opening. 

These doors install by welding or bolting the flanged frame to the bulkhead (half of the flanged frame width normally extends into the bulkhead opening, allowing room for frame wedges and dog operation). 

All fabricated doors are available in aluminum, steel, stainless steel or a combination of these metals. 

SPECIFICATIONS: 

• Required bulkhead cutout is the clear-opening dimension plus 3"

• Flange-to-flange size is clear-opening dimension plus 6"

• Corner cutout radius is 9 ½"

• Door Swing is clear-opening width plus 7", as measured from the hinge pin. This radius is important in case there are stairs, railings, pumps, etc. within this area, that would prevent the door from fully opening.

• Steel door panel is 3/16" in standard grade, ¼" in ABS grade.

• Steel door frame is ¼" x 2" x 3" in standard grade, 5/16" x 2" x 3" in ABS grade.

• Contact Freeman Marine for Drawing 109 Specifications.